Installation steps for bending

Preparation: Determine the location and direction of the bending, and clean and level the installation area.

Installation of fixing bracket: according to the size and weight of the bend, select the appropriate fixing bracket, and use screws or other fixing materials to install it firmly on the wall or floor.

Connecting pipes: Connect the pipes that need to be connected to the bend to the bend components. This may involve the use of appropriate fittings, sealants and other tools and materials.

Adjust Angle: Adjust the angle of the bend as required. This may involve the use of tools to tighten or loosen the connecting parts to achieve the required angle.

Testing and Commissioning: After completing the installation, perform tests to ensure that the bending components are working properly and that there are no leaks or other problems. This can be done by running water or gas through the pipe.

Please note that the above steps are for guidance only and specific installation procedures may vary depending on the type of bending and specific requirements. It is recommended that you refer to the relevant bending instruction manual or consult a professional during installation to ensure proper installation.